How to use the gears

Press the clutch fully before shifting the gear stick into one of the positions shown in the diagram in fig. 2 (the diagram is also on the gear lever knob).

IMPORTANT

Only engage the reverse gear when the vehicle is completely stationary. With the engine running, wait for at least 2 seconds with the clutch pedal pressed to avoid damaging the gears and scratching.

To engage reverse (R) from neutral:

– shift the lever to the right and back.

For version 1.4 8V and 1.6 16V, to engage reverse (R) from neutral, raise collar A-fig. 3 set under the knob and move the lever rightwards and then backwards at the same time.

You must press the clutch fully down to change gear properly. It is therefore

You must press the clutch fully down to change gear properly. It is therefore essential that there is nothing under the pedals. Make sure that mats are lying flat and do not get in the way of pedals.

    See also:

    Child lock (5-door versions)
    To prevent opening the rear doors from the inside. This device can be engaged only with doors open: ❒ position 1 - engaged (door locked); ❒ position 2 - disengaged (door openable fr ...

    8. Generic Warning Light
    The Generic Warning Light will illuminate if any of the following conditions occur: Oil Change Request, Engine Oil Pressure Sensor Failure, External Light Failure, Fuel Cut-Off Intervention, Fue ...

    Cylinder replacement procedure
    To replace the cylinder proceed as follows fig. 16h: – disconnect connection A; turn counter-clockwise the cylinder to replace and raise it; fit the new cylinder and turn it clockwise; connect conn ...