Multifunction display

STANDARD SCREEN fig.

The standard screen shows the following indications:

A - Headlight aiming position display (with dipped beam headlights on).
B - Clock.
C - Odometer (km or miles covered).

Note With ignition key removed, when opening one of the front doors the display comes on showing the clock and km/mi covered for a few seconds.

CLOCK fig. 42

CLOCK fig. 42

To adjust the clock press button A to increase minutes and button B to decrease minutes. The clock will advance by one unit each time the button is pressed. Press the button and hold it down for a few seconds to rapidly advance the time automatically.

When the clock draws near to the correct time, release the button and complete the regulation manually.

WARNING LIGHT TEST fig. 43

WARNING LIGHT TEST fig. 43

The following warning lights are tested:

– handbrake on/low brake fluid level;
– ABS and EBD system (where provided);

This tests are carried out automatically when turning the ignition key to MAR and during normal operation when a fault is found. At the end of the initial check, the display will show failures, if any (through one or more warning lights) by the wording LEd Err flashing for about 10 seconds.

Reconfigurable multifunction display (where provided)

    See also:

    Spare Tire Removal
    The spare tire is stowed to the underbody below the cargo area. 1. Remove the plug located in the rear cargo area. Winch Access Plug 2. Fit the wrench tool over the drive nut. Use the wrench to ...

    Manual Transmission – If Equipped
    Lubricant Selection Use only the manufacturers recommended transmission fluid. Refer to “Fluids, Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for further information. Fluid Level C ...

    Generic failure indication
    (amber) The warning light turns on in the following circumstances. Engine oil pressure sensor failure The warning light comes on when the engine oil pressure sensor is faulty. Contact Fiat Deale ...