“STANDARD” SCREEN fig. 38
The standard screen shows the following indications:
A - Headlight aiming position display (with dipped beam headlights on).
B - Clock (always displayed, also with key removed and front doors closed).
C - Odometer (km or miles covered).
CONTROL BUTTONS fig. 39
A - Clock.
CLOCK fig. 39
To adjust the clock press button A.
The clock will advance by one unit each time the button is pressed. Press the button and hold it down for a few seconds to rapidly advance the time automatically. When the clock draws near to the correct time, release the button and complete the regulation manually.
WARNING LIGHT TEST fig. 40
The following warning lights are tested:
– handbrake on/low brake fluid level;
– ABS and EBD system (where provided);
This tests are carried out automatically when turning the ignition key to MAR and during normal operation when a fault is found. At the end of the initial check, the display will show failures, if any (through one or more warning lights) by the wording “LEd Error” flashing for about 10 seconds.
It’s a function of ESP system and controls the vehicle drive and cuts in automatically every time one or both driving wheels slip. In slipping conditions, two different control systems are activate ...
Activation/deactivation (CITY function)
To connect/disconnect the CITY function, push the button located on the central tunnel . Activation of this function is indicated by the word CITY on the instrument panel (see figures beside). ...
Manual Heating And Air Conditioning
Manual Temperature Control (MTC) 1. Temperature Control Rotate this control to regulate the temperature of the air inside the passenger compartment. Rotating the dial to the left into the blue ...