Adjusting the front seat belt height

Always adjust the height of the seat belt to fit the person wearing it. This Make the height adjustment when the vehicle is stationary.

Always adjust the height of the seat belt to fit the person wearing it. This could greatly reduce the risk of injury in the case of collision.

The belt is adjusted properly when the webbing passes approximately halfway between the edge of the shoulder and the neck. Four height adjustments are possible.

To raise the belt: raise loop A-fig.

8 to the required position.

To lower the belt: press knob B, and at the same time move loop A to the required position.

Check that the seat belt is locked in position by pushing down on loop A without pressing knob B.

After you have made the adjustment, always make sure that the loop is attached

firmly in one of the fixed positions and cannot move. To do this, with the button After you have made the adjustment, always make sure that the loop is attached firmly in one of the fixed positions and cannot move. To do this, with the button released, exert a further pressure to allow the anchoring device to catch if release did not take place at one of the preset positions.

    See also:

    Tire Rotation Recommendations
    The tires on the front and rear of your vehicle operate at different loads and perform different steering, driving, and braking functions. For these reasons, they wear at unequal rates and tend to ...

    Jacking the vehicle
    WITH THE JACK See “If a tyre is punctured”, in this section. The jack should only be used to change a wheel on the vehicle for which it was designed. It should not be put to other uses or employe ...

    Jacking the car
    WITH THE JACK See “If a tyre is punctured” in this section. WITH A SHOP JACK From the front Jack up the car only by positioning the jack arm at the gearbox/differential and placing a rubber ...