Door lockremote control

The remote control is built into the ignition key. Press button A-fig. 4 to lock and unlock the doors.

Press button A to operate the system.

LED B (where required) will flash while the transmitter is sending the code to the receiver.

The ceiling light and map-reading light will come on for the predefined time when the doors are unlocked with the remote control.

For ordering additional remote controls or replacing the batteries, see the following

For ordering additional remote controls or replacing the batteries, see the following paragraphs.

IMPORTANT

The remote control system frequency can be disturbed by significant radio transmissions outside the vehicle (e.g: mobile phones, HAM radio systems, etc.) that could cause remote control malfunctioning.

Ministerial homologation

In accordance with the legislation covering radio frequencies in force in each country, we should like to point out that:

– the market-specific homologation numbers are listed in the paragraph “Radio-frequency remote controls” in section “Technical specifications”.

– for markets requiring transmitter marking, the transmitter code is printed on the remote control.

ORDERING ADDITIONAL REMOTE CONTROLS

The system can recognize up to 8 keys with incorporated remote control.

If additional remote controls are required for any reasons, go to a Fiat Dealership, taking all the keys you own and the CODE card with you.

REPLACING THE BATTERIES

Change the batteries (using spare batteries of the same kind) as follows.

Open the plastic case by inserting a screwdriver in recess A-fig. 5. Insert new batteries B respecting the polarity and close the plastic case.

Used batteries are harmful to the environment.

Used batteries are harmful to the environment.

They should be disposed of as specified by law in the special containers provided, or take them to a Fiat Dealership, which will deal with their disposal.

    See also:

    Cold Weather Operation
    To prevent possible engine damage while starting at low temperatures, this vehicle will inhibit engine cranking when the ambient temperature is less than –22° F (–30° C) and the oil temperature se ...

    FRONT SEATS
    Moving the seat backwards or forwards Lift the lever (A) (on seat internal side) and push the seat forwards or backwards: in the driving position the arms should rest on the rim of the steering w ...

    Front Seats Forward/Rearward Adjustment
    The adjusting bar is located at the front of the seats, near the floor. Adjusting Bar While sitting in the seat, lift up on the bar and move the seat forward or rearward. Release the bar once t ...