Blades

Periodically clean the rubber part using special products; TUTELA PROFESSIONAL SC 35 is recommended.

If the rubber blades are bent or worn they should be replaced. In any case they should be changed once a year.

A few simple notions can reduce the possibility of damage to the blades:

❒ if the temperature fall below zero, make sure that ice has not frozen the rubber against glass. If necessary, thaw using an antifreeze product;
❒ remove any snow from the glass: in addition to protecting the blades, this prevents effort on the motor and overheating;
❒ do not operate the windscreen and rear window wipers on dry glass.

WARNING

Driving with worn wiper blades is a serious hazard, because visibility is reduced in bad weather.

Changing the windscreen wiper blades

Changing the windscreen wiper blades

Proceed as follows:

❒ raise the windscreen wiper arm (A) and position the blade so that it forms an angle of 90° with the arm;
❒ press tab (B) of the coupling spring and remove the blade to be replaced from the arm (A);
❒ fit the new blade by inserting the tab into the special slot in the arm. Make sure it is properly locked into place.

Changing the rear window blade

Changing the rear window blade

Proceed as follows:

❒ raise the cover(A) and remove the arm from the car, slackening the nut (B) that fastens it to the pivot pin;
❒ fit the new arm, positioning it correctly, and fully tighten the nut;
❒ lower the cover.

SPRAY NOZZLES

Windscreen wiper

Windscreen wiper

If the jet of fluid is inadequate, firstly check that there is fluid in the reservoir: see “Checking fluid levels” in this section).

Then check that the nozzle holes are not clogged, if necessary use a needle.

The windscreen jets are directed by adjusting the angle of the nozzles: turn the nozzle cylinder by inserting a screwdriver in (A).

Fluid jets shall be directed at about 1/3 height from the window upper edge.

Rear window wiper

Rear window wiper

Rear window washer jets can be adjusted in the same way. The nozzle holder is on the rear window.

    See also:

    Car protection system failure - fiat code
    Turning the key to MAR the warning light on the dial shall flash only once and then go off. If with the ignition key at MAR the warning light stays on, this indicates a possible failure (see “Th ...

    FRONT SEATS
    Moving the seat backwards or forwards Lift the lever (A) (on seat internal side) and push the seat forwards or backwards: in the driving position the arms should rest on the rim of the steering w ...

    Refuelling
    To guarantee full tank filling, carry out two refueling operations after the first click of the fuel delivery gun. Avoid further topping up operations that could cause damages to the fuel system. ...