The tow ring provided with the car is housed in the tool box under the boot mat.
TOW HOOK PLUG REMOVAL PROCEDURE
To prevent damaging plug (A), proceed as follows:
❒ take the screwdriver provided out of the tool container;
❒ fit the screwdriver down into the plug slot (B) for about 1 cm;
❒ place your thumb on the plug to prevent damaging it (see figure);
❒ remove the plug (without turning it) making a movement perpendicular to the supporting surface (see figure).
TOW RING HOOKING
Proceed as follows:
❒ take the tow hook from its support;
❒ tighten the hitch (B) on the front or rear threaded pin.
Before starting to tow, turn the ignition key to MAR and then to STOP. Do not remove the key. If the key is removed, the steering lock engages automatically resulting in the impossibility to steer the wheels.
When towing, remember that without the help of the servobrake and power steering, a greater effort is required on the pedal and steering wheel. Do not use flexible cables for towing and avoid jerks. During towing operations make sure that fastening the joint to the car does not damage the components in contact with it. When towing the car, you must comply with the specific traffic regulations regarding the tow ring and how to tow on the road.
Do not start the engine when towing the vehicle.
Air comes from the floor, defrost and side window demister outlets. This mode works best in cold or snowy conditions. It allows you to stay comfortable while keeping the windshield clear. ...
General instructions for using the seat belts
The driver is responsible for respecting and enforcing the local rules and laws regarding the use of seat belts. Always fasten the seat belts before starting. For maximum safety, keep the back of ...
Rear Head Restraints
To raise the head restraint, pull upward on the head restraint. To lower the head restraint, press the push button, located at the base of the head restraint, and push downward on the head restrai ...