Proceed as follows:
❒ Position the involved wheel with the inflation valve (A) set as shown in the figure, then pull up the handbrake;
❒ Screw the filler hose (B) to the cylinder (C);
❒ Loosen tyre inflation valve cap, remove valve internal element using the proper tool (D), taking care to protect it against sand or dirt;
❒ Fit the filler hose (E) to the tyre inflation valve, keep the cylinder (F) with the hose set downwards then press to make the sealing fluid flowing into the tyre;
❒ Refit valve internal element using tool (G);
❒ Engage and then lock, using the proper lever (H) the air compressor hose (L) to the tyre inflation valve;
❒ Start the engine, fit the plug (N) in the cigar lighter (or 12V outlet) and inflate the tyre to the proper pressure value. Check tyre pressure on gauge (M) with compressor to obtain precise reading;
❒ Should it be impossible to reach the pressure specified, move the car forward
or backward for approx. ten metres in order to distribute the sealing fluid inside
the tyre, then repeat the inflation operation;
❒ If after this operation it is still impossible to obtain the specified pressure, stop driving and contact immediately Fiat Dealership;
❒ After reaching the proper tyre pressure, start driving immediately to distribute the sealing fluid inside the tyre evenly. After about 10 minutes, stop and check the tyre pressure again; engage the handbrake;
❒ Drive with the utmost care to the nearest Fiat Dealership to have the tyre checked and repaired or replaced. It is of vital importance to communicate that the tyre has been repaired using the quick tyre kit
IMPORTANT Tyre repaired with this kit can be used only temporarily.
Apply the sticker in a visible position for the driver to indicate that the tyre has been treated with the quick tyre repair kit. Drive carefully especially when cornering. Do not exceed 80 km/h and avoid heavy braking and accelerating.
If read pressure is below 1.3 bar, stop immediately and contact Fiat Dealership. If read pressure is equal to at least 1.3 bar, restore proper pressure (engine running and handbrake on) and then drive with the utmost care.
If when restoring pressure it is impossible to reach at least 1.8 bar, stop immediately since the tyre is too damaged and the quick repair kit cannot guarantee proper seal, contact Fiat Dealership.
Engine coolant fluid
The coolant level shall be checked with cold engine and shall be included between the MIN and MAX mark on the reservoir. If the level is low, pour slowly a mixture of 50% distilled water and 50 ...
Warnings And Cautions
This Owner’s Manual contains WARNINGS against operating procedures that could result in a collision or bodily injury. It also contains CAUTIONS against procedures that could result in damage to yo ...
Low engine oil pressure
Turning the key to MAR the warning light on the dial turns on, but it should go off as soon as the engine is started. If the warning light turns on when the car is travelling (on certain ver ...