To close the bonnet

Proceed as follows:

❒ hold the bonnet up with one hand and, with the other, remove rod (C) from recess (D) replace it in its clip;
❒ lower the bonnet at approx. 20 cm from the engine compartment and then let it drop, ensuring that it is fully closed and not just held in position by the safety catch. If the bonnet does not close properly do not push it down but open it again and repeat the above procedure.

IMPORTANT Always check that the bonnet is closed properly to avoid its opening while the car is travelling.

WARNING

For safety reasons the bonnet shall always be perfectly closed when travelling. Always check for proper bonnet locking. If the bonnet is left inadvertently open, stop the car immediately and close the bonnet.

WARNING

The bonnet might fall violently if the support rod is not positioned properly.

WARNING

Perform the above operations when the car is stationary.

    See also:

    Engine Oil Filter
    The engine oil filter should be replaced with a new filter at every engine oil change. Engine Oil Filter Selection All of this manufacturer’s engines have a full-flow type disposable oil filter. ...

    “Distance unit” (Dist. Unit)
    The display gives information according to the set unit (km or mi). To select the required distance units, proceed as follows: ...

    Vehicle Storage
    If you are leaving your vehicle dormant for more than 21 days, you may want to take these steps to protect your battery. • Disconnect the negative cable from the battery. • Anytime you store your ...