Extending the boot

Single rear seat

Proceed as follows:

Proceed as follows:

❒ fasten the seat buckles to the tabs on the seat back (as shown by arrows);
❒ check that the webbing (A) of each of the two side seat belts is inserted into the respective belt guiding catch (B);
❒ release the seat back moving the levers (C) as shown by the arrow. Tilt it to make a single loading surface with the boot floor.

Split rear seat back (where provided)

The boot can be extended completely or partially.

The boot can be extended completely or partially.

For partial extension fold the required seat side; proceed as follows:

❒ remove the parcel shelf (see next paragraph);
❒ press the button by the side of the two supports and remove the head restraints by pulling them upwards;
❒ check that the webbing (A) of each of the two side seat belts is inserted into the respective belt guiding tongue (B);
❒ release the seat back moving lever (C), then tilt it.

To fold the whole seat, lift the cushion and then tip the seat backs as described

To fold the whole seat, lift the cushion and then tip the seat backs as described for the rear single seat.

The central three-point seat belt and reel mechanism (where fitted) can be removed as follows:

❒ press the black button on the buckle (A) if the seat belt is fastened;
❒ take the central belt slowly to the loop retainer (B) on the upper part of the seat back and remove the second tongue (C) from the loop retainer;
❒ remove the first tongue (D) from the loop retainer and fasten it to the specific pin (E) on the rear pillar panel;

To restore conditions for use:

❒ release the first tongue (D) from pin (E);
❒ insert the first tongue (D) in loop retainer (B) without twisting the belt. Make notch (F) on the belt tongue coincide with the respective groove on the loop retainer and insert the second tongue (C) in the loop retainer;
❒ pull the belt gently through loop retainer (B), and fasten the first tongue (D) in buckle (A) (grey with black button). Make the two yellow dots (one on the tongue and one on the buckle) coincide.

    See also:

    How to warm up the engine after is has just started (petrol and diesel versions)
    – Begin to move forward slowly letting the engine turn at medium revs. Do not accelerate abruptly. – Do not push the engine to its limit for the first few kilometers. You are recommended to wait u ...

    Air bag failure
    Turning the ignition key to MAR the warning light on the dial turns on, but it should go off after few seconds. The warning light stays on glowing steadily (on certain versions together with t ...

    If an interior light burns out
    Modifications or repairs to the electrical system carried out incorrectly and without bearing the features of the system in mind can cause malfunctions with the risk of fire. See “If a bulb burn ...