Deactivation

Turn the ignition key to STOP.

At the following starting operation (key at MAR), the sensor will not be reactivated even is the stalk is on (B). In this event, to activate the rain sensor, you have to move the stalk to (A) or (C) and then again to (B).

When the rain sensor is again activated in this way, at least one windscreen wiper stroke occurs, even if the windscreen is dry.

The rain sensor is able to recognize and automatically adjust itself in the presence of the following particular conditions:

❒ impurities on the controlled surface (salt, dirt, etc.);
❒ straks of water caused by worn wiper blades;
❒ difference between day and night.

Do not activate the rain sensor when washing the car in an automatic washing station.

In the event of ice on the windscreen, make sure to have disconnected the device.

WARNING

Make sure the device is off when cleaning the windscreen.

    See also:

    Rear fog lights
    (amber) The warning light turns on when the rear fog lights are turned on. ...

    Rear light cluster
    To replace a bulb, proceed as follows: Versions equipped with rear brackets: 1) Working inside the vehicle: remove the plastic cover fig. 25 set on the speaker seat fitting the screwdriver under t ...

    Fuel filler cap
    To open the cap, turn it anticlockwise and then remove it. During refuelling, secure the cap to the anti-loss device on the flap as shown in the figure. On certain versions the cap has a keylock ...