Trip computer

Pressing button , the “Trip computer”

Pressing button function gives is displayed, information relating to the operating status of the, the “Trip computer” function gives is displayed, information relating to the operating status of the car. This function is resettable.

Values displayed are: Range to empty, Distance travelled, Average consumption, Instant consumption, Average speed, Trip time (driving time). Value selected will be displayed until a new information is requested.

(*) When the Instant consumption value is displayed, the word TRIP will not be displayed.

Start of journey procedure (reset)

To start a new journey, with the key to MAR, press button (see paragraph “Control buttons”). with mode IMPORTANT “Range to empty” information cannot be reset.(see paragraph “Control buttons”).

IMPORTANT “Range to empty” information cannot be reset.

Range to empty = shows the distance in km (or miles) that the car can still cover before needing fuel, assuming that driving conditions are kept unvaried. The display will show “- - - -” in the following cases:

❒ range lower than 50 km;
❒ car parked with engine running for long time; when restarting range indication will be displayed again

Distance travelled = shows the km (or miles) covered from the start of the new mission (*).

Average consumption = shows the average consumption calculated from the start of the new mission (*); this value can be expressed in km/l or l/100 km or in mpg.

Instant consumption = shows fuel consumption variation, this value is updated constantly. If the car is parked with engine running the display will show “- - - -”. When restarting the car, the instant consumption indication will be displayed again.

Average speed = shows the average speed of the car in relation with total time elapsed from the start of the new mission (*).

Trip time = time elapsed from the start of the new mission (*).

(*) New mission = starts from last reset:

– “manual” reset is performed by the driver by pressing the relevant button (see paragraph “Control buttons”)
– “automatic” reset is performed when the Distance travelled reaches 3999.9 km or when Trip Time reaches 99:59 (99 hours and 59 minutes)
– after reconnecting the battery.

IMPORTANT Lacking information, Trip computer values are displayed with “- - - -”. When restoring normal operating conditions after a failure, calculation will restart regularly without resetting either previous displayed values or the start of a new mission (*).

IMPORTANT After disconnecting/reconnecting the battery, certain displayed values will be equal to “- - - -” until significant data for recalculation are available.

    See also:

    Adding Washer Fluid
    The windshield washer fluid reservoir is located in the engine compartment, and the fluid level should be checked at regular intervals. Fill the reservoir with windshield washer solvent (not engin ...

    Accessories purchased by the owner
    If after buying the car, you decide to install electrical accessories that require a permanent electric supply (alarm, satellite antitheft system, etc.) or accessories that in any case burden the ...

    Move slider (B) to . This function is particularly useful when the outside air is heavily polluted (in a traffic jam, tunnel, etc.). However, it is better not to use it for long periods, especial ...