NOTE: Lubricate the top rails with Berulub FR 43 every 2000 cycles or if scratching noises due to dust are present.
Failure to follow these cautions may cause interior water damage, stains or
mildew on the top material:
• Avoid high-pressure car washes, as they can damage the top material. Also, increased water pressure may force past the weather strips.
• Remove any standing water from the top and dry the surface before opening it. Operating the top, opening a door or lowering a window while the top is wet may allow water to drip into the vehicles interior.
• Use care when washing the vehicle, water pressure directed at the weather strip seals may cause water to leak into the vehicles interior.
Immediate removal of any contaminant is recommended.
Regular washing of the top will enhance its life and appearance, and make successive cleanings easier. Do not subject the top to excessive heat. Frequently vacuum the top and storage compartment.
Hand washing is highly recommended. Automatic car washing equipment can damage the top material. If you must use an automatic car wash, soft cloth systems are preferred.
Avoid high-pressure car washes, as they can damage the top material. Also, increased water pressure may force water past the weather strips.
Careful vacuuming of the top before washing is helpful in removing dust and other foreign particles. Wash in partial shade instead of direct sun. Wet the entire vehicle before washing the top. The top should be washed with a soft, natural bristle scrub brush, and a mild soap solution such as liquid dishwashing soap. Do not use detergent.
Never use an abrasive type cleaner or bleaches.
Cleaners should not contain silicones, organic solvents, petroleum distillates, or plasticizers. Always wait until the top is thoroughly dry before lowering it into the storage area.
Scrub in all directions, covering an area of about two square feet at a time. Avoid heavy scrubbing. Rinse the entire vehicle with water to remove all soap and dirt from the top fabric and to prevent streaking on painted and chrome surfaces. Allow the top to dry before lowering.
Vacuuming the top with a wet/dry shop vacuum will decrease the top’s drying time, ensure removal of all dirt, and delete streaks in the material. Multiple cleanings may be necessary to remove stubborn stains. If stains persist, contact your local authorized dealer for further suggestions.
Turning the ignition key to MAR the warning light on the dial turns on, but it should go off after few seconds. The warning light turns on when the handbrake is on. IMPORTANT If the warning lig ...
Air comes from the floor outlets. Aslight amount of air is directed through the defrost and side window demister outlets. Bi-Level Air is directed through the panel and floor outlets. Press an ...
To close, lower the tailgate until the lock clicks. If the boot is not shut properly the warning light ´ comes on together with the message on reconfigurable multifunction display (where prov ...