Preparations For Jacking

1. Park the vehicle on a firm level surface, avoiding ice or slippery areas.

Do not attempt to change a tire on the side of the vehicle close to moving WARNING!

Do not attempt to change a tire on the side of the vehicle close to moving traffic, pull far enough off the road to avoid the danger of being hit when operating the jack or changing the wheel.

2. Turn on the Hazard Warning flashers.
3. Set the parking brake.
4. Place the shift lever in PARK (automatic transmission) or REVERSE (manual transmission).
5. Turn Off the ignition.
6. Block both the front and rear of the wheel diagonally opposite the jacking position. For example, if changing the right front tire, block the left rear wheel.

NOTE: Passengers should not remain in the vehicle while the vehicle is being

jacked. NOTE: Passengers should not remain in the vehicle while the vehicle is being jacked.

    See also:

    General Information
    This device complies with Part 15 of FCC rules and with RS-210 of Industry Canada. Operation is subject to the following conditions: 1. This device may not cause harmful interference. 2. This dev ...

    Service schedule
    (*) Or every 3 years for particularly demanding use: - cold/hot climates; - driving in the city idling for a long time; - dusty roads or roads covered with sand and/or salt Or every 5 years, r ...

    Fitting diagram
    The trailer tow hitch is to be fixed in the points indicated (see diagram fig. 4). The plate 1 must have a minimum thickness of 6 mm. The fastening points 2 will be equipped with shims 􀂒1 ...