Change Engine Oil
Your vehicle is equipped with an engine oil change indicator system. The “Change Engine Oil” message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate, dependent upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the MENU/ESC button. To reset the oil change indicator system (after performing the scheduled maintenance), refer to the following procedure.
1. Turn the ignition switch to the ON position.(Do not start the engine.)
2. Fully depress the accelerator pedal slowly, three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.
The Trip Computer is located in the instrument cluster. It features a driver-interactive display (displays information such as; trip information, range, fuel consumption, average speed and travel time).
Engine coolant temperature gauge
This gauge shows the temperature of the engine coolant fluid and begins working when the fluid temperature exceeds approx. 50 °C. Under normal conditions, the needle should move to different positi ...
Front Fog Lights — If Equipped
The fog light switch is located on the center stack of the instrument panel, just below the radio. Fog Light Switch Press the switch once to turn the front fog lights on. Press the switch a sec ...
If an exterior light burns out
For the type of bulb and power rating, see “When needing to change a bulb”. ...