Rear Windshield Wiper

Rotate the end of the windshield wiper/washer lever upward to the first detent past the intermittent settings for intermittent wipe operation. With the front windshield wiper active, rotate the end of the windshield wiper/washer lever upward. The rear wiper will operate in the same mode as the front windshield wipers, but at half the frequency. When the transmission is shifted into REVERSE, the rear wiper will automatically operate at Low Speed and return to normal operation when the transmission is shifted out of REVERSE.

Rear Wiper Operation
Rear Wiper Operation

ON/RUN position. NOTE: The windshield wipers/washers will only operate with the ignition in the ON/RUN position.

Rear Windshield Washer Operation

Push the windshield wiper/washer lever toward the instrument panel to activate the rear washer. Push and hold the lever for more than a half second and the wipers will activate automatically for three cycles after the lever is released.

    See also:

    Refuelling
    To ensure full tank refuelling, carry out two top-up operations once the delivery gun has turned off twice. Avoid further top-up operations which could cause faults in the fuel system. The car mu ...

    Main beam headlights
    To change the halogen bulb, proceed as follows: 1) Remove the protection cover Cfig. 18 turning it counterclockwise; 2) Release clip A-fig. 19, remove connector B and remove the bulb C. ...

    Electronic Vehicle Information Center (EVIC)
    The Electronic Vehicle Information Center (EVIC) features a driver-interactive display that is located in the instrument cluster. Electronic Vehicle Information Center (EVIC) Display The EVIC ...