Engine Break-In Recommendations

A long break-in period is not required for the engine and drivetrain (transmission and axle) in your vehicle.

Drive moderately during the first 300 miles (500 km).

After the initial 60 miles (100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.

While cruising, brief full-throttle acceleration within the limits of local traffic laws contributes to a good break-in.

Wide-open throttle acceleration in low gear can be detrimental and should be avoided.

The engine oil installed in the engine at the factory is a high-quality energy conserving type lubricant. Oil changes should be consistent with anticipated climate conditions under which vehicle operations will occur. For the recommended viscosity and quality grades, refer to “Maintenance Procedures” in “Maintaining Your Vehicle”.

Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage CAUTION!

Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may result.

of operation. This should be considered a normal part of the break-in and not interpreted NOTE: A new engine may consume some oil during its first few thousand miles (kilometers) of operation. This should be considered a normal part of the break-in and not interpreted as an indication of difficulty.

    See also:

    Roof rack/ski rack
    PRESETTING To use the roof racks you shall remove the caps set in points fig. 136. Attach the roof rack bar brackets to the fasteners. IMPORTANT Always follow the instructions provided with the ki ...

    For checking and restoring pressure only
    The compressor can be also used just for restoring pressure. Disconnect the quick connection and connect it directly to the tyre valve; in this way the cylinder is not connected to compressor and ...

    Sidelights and low beams
    The warning light on the dial turns on when sidelights, parking lights or low beams are turned on. ...